Back To page 25
This shows how the pedal bracket interfaces with the bell crank bracket.
Truck firewall will be located along a vertical line below the vice grips.
Master cylinder and hydroboost unit bolt to four bolts sticking up.
This arrangement places master cylinder parallel to firewall
This was taken from the operator's perspective and shows replacement bumper bracket.
Return spring had to be relocated to a new location.
It used to run horizontally but could no longer do that after bracket was sectioned.
Shiny part will be located on opposite side of firewall.
This shows the extensive modifications to the brake pedal bracket to make it fit under the stock dash.
The column drop and bumper bracket (on the left) was cut off and the section to the lower right was taken out.
Will have to shorten actuating rod a corresponding amout.