Back To Page 146
These sections were saved from an old Hood I had lying around, don't know what make but not Ford.
Just uses the same setup.
This is where they will fit into the Hood Panel.
I used an Epoxy Bond to Glue them in, talk about strong !!!, now for the filing and sanding to clean the area up.
These are the Handles that are part of it, I have compared them to 36 Ford ones and
the only difference is the upward Curve.
Because of the thickness of the Fibreglass the Handle section where they go through
will need to be extended and a new Holes drilled for the Split Pins, these will be Chromed.