My 1941 Ford COE P181
     Back                                                                              To Page 182 As part of the process of hinging the bed from the rear, this area about the wheels needs to be re-enforced and
I need to be able to drive over the rear wheel arch so I am building this Arch below, I will need to make 4 of these, of which 2 will go on the outer edge of the bed and 2 will go next to the Chassis rails next to the inner wheels,
I was going to get them professionally bent but not at the cost of $300, so I will be making them by cutting and bending,
maybe a lot more work but a lot cheaper, this one still needs to be cleaned up before I weld it in place.