This corner section was removed from the RH side so that the
Fender had room, it will now be fitted to the LH side, just happens
to fit just right, closer then how I am holding it.
Here you see it welded into position, although it did end up
a bit different then in this photo, see if you can notice it
Here it is with the temporary timber floor in place
I am thinking of making these Fender Cover frame extensions
At the front of the Fender as well, time will tell if I do these
Here is the RH side of the Bed.
The Rod you can see will be used to release the Fender support
from the Bed Frame. It will be spring loaded and have a pull knob on the end