What you see here is a piece of 3" x 3" Angle which will be
mounted up the opposite way to the pic and in between the
Dually wheels to allow my Willys Coupe to be driven onto
the bed I did not have enough suspension clearance to allow it
to remain straight, I have 3 1/2" on the bump stops, this now
gives me 4" of wheel and tire clearance.
Here you can see a straight edge showing the bow which was
created by a series of cuts every 2" and then welding it on both sides
These welds will remain as they are except for minor clean up
The outer side has been ground out to get a better penetration on the welds
Here you can see the Wheel Arches welded into place with the
down part of the angle in between the two wheels
And the LH side