Back                                                                                                  To page 519

What you see here is the beginning of the Blower base plate which
 will go under the LPG Mixer

This attaches to the Blower mount side box

And the the Blower case attaches to the box using the 4 on each side SHCS.

Like this as shown above

After trial fitting the base plate a larger area had to be
cut out for all the LPG Hoses etc

The front of the blower case was opened up so the snout could be bolted on


A view of the rear of the Blower,
 This Blower case was made by Barry Burton in QLD

A view from the inside showing how the blower was bolted on to the base

After some cleaning up and welding this is how it looked upside down