Back To Page 299
One Transmission mount to suit the FMX Transmission
This was manufactured from one of the spare bed crossmembers that I had when the bed was shortened to suit
the C20 Chassis, it measures 75 x 50 mm and bolts to three original Chassis holes,
only one new hole needed to be drilled on either side.
As you can see two larger holes were drilled into the underneath of the crossmember to accept the Rubber Mount Stud nuts.
Here is the new Crossmember fitted in place and never to be removed,
it needed to go in with a big hammer, It was a tight fit !!
Ground clearance is just over 8", which is more then the Engine Crossmember.
The Trans crossmember will be giving it's final coat of paint when final fitting of the Trans takes place.