My COE Page 375
Back                                                                                                   To page 376
911
Well the RH Fender is finally ready for etch primer
912
But this brought about another problem, one that I should have spotted before but didn't
and that is that the gap between door arch and Fender just wasn't big enough, so if
 you look real carefully you will see where I have scribed a line about 3/16" above the Fender

913
So the Door was removed and the bottom edge was opened up and flattened out.
916
The edge was then refolded and tack welded, a smear of Bondo on both sides
and it was done.
916
Now this is a much better gap, no chance of scraping on the Fender.