Well you may notice a few things here, the new Form Ply Floor has been fitted,
this will be covered polished 3 mm tread plate Aluminium soon !!
Also I finally managed to get some large Reflectors that fit the Bezels properly
A red RH taillight lens has been cut from a large square one, so another job done
Also a Stainless Number plate panel and lights have also been fitted and wired.
This area will be covered by polished 3mm Aluminium tread plate soon.
There ya go all covered up and looking good, initially the curved section
were supposed to butt up to the black frame but as they were being made
I thought it would be better to have a bit more flat floor room, so a fill in panel
was made 5" wide and the curved panel pushed outwards, the outer 5" will
be trimmed of after the final fit of the fender.