Back                                                                                                   To page 503
  
What you see here is a sample of what I am attempting to do,
 an 8" wide strip of 3mm Aluminum checker plate is to be rolled
over the outer tube on both ends and bent to a 15" tire radius
   
This Aluminum wheel support is able to be moved in or out as
 required depending on track width.
  
So here is the finished result, the section that rolls around the tube
 has another tube inserted in it so that it will slide
  
Here is how it will work, the Aluminium will slide, depending
on the track width of the car being carried. Just in case
 I have added a couple of vertical supports which are welded to the
bottom of the frame with just enough clearance to miss the Aluminium roll.
   
On the left you can see both stands , they will attach to the bed
 by 4  1/4" SHCS  This is how a wheel will fit on the stands
with a strap going over the wheel and attached to two ring bolts
which have yet to be fitted to the Bed.