Back                                                                                                  To page 521

Every Blower needs a snout, right , a s/s plate, some tube,
 in the end the water pump section wasn't used.

A 1/2" thick Aluminum piece was found and trimmed down
Sure would be nice to have a Lathe at this point !!

With a 3/4"hole and bolt fitted into place, you can just see
where the round S/S plate was welded to the other end

4 x 3/8" Button Head Bolts were fitted to the Gilmer Belt Pulley

And cut of level with the Aluminum Plate

And here is how it all fits together

You can just see where the s/s plate has been welded on at the other end

These are some of the parts that were used, the Gilmer belt Pulleys were a swap meet buy