Back                                                                                                  To page 522

And after many hours of sanding filling sanding filling by me and my son Matt the "Blower"
finally received a coat of paint

A slightly different view

And complete with snout

Time to fit the blower to the engine, also showing the kick down cable set up.

and the other side showing the Accelerator set up


And then the sides get fitted


And the other side

Now for those who have been paying attention you can see that the blower snout has been shortened
There will be a 3mm Aluminum plate fitted to the top of the blower to support the weight of the Carbs

And the other side, notice the close confines with the distributor and also the angle
 of the blower base compared to the valve covers, this will be rectified.

So with two QJet Carbs fitted and my Air Scoop on top it is starting to look real,
notice the angled plate on the blower base, it does remove the visual angle problem